Jeep Mount Installation

 

Drilling Mount Holes	Installed Mount	Complete Install

Note: The rearward part of the fender on newer Jeeps does not have the same support that was found in earlier models. On these vehicles we recommend that the bracket be mounted at least 8-inches (20cm) forward of the rear edge of the fender where it has sufficient support. If this is not followed, or if the rear part of the fender is not given additional support, the fender, dependent upon the antenna size, will flex from any whipping action of the antenna. See the following for guidance.

Courtesy of:

Firestik Antenna Company
2614 East Adams St.
Phoenix, AZ 85034